installing Phat Cats in a SG pro (Push pull pots)

Discussion in 'Epiphone SG' started by chocolatejesus, Apr 8, 2020.

  1. chocolatejesus

    chocolatejesus New Member

    Joined:
    Apr 8, 2020
    Messages:
    1
    Likes Received:
    0
    Hi everyone

    I have lurked around here a Bit nur could Not find a solution for this.
    I know how to solder but i am Not really an expert on Pickup wiring.

    I snagged a cheap epi SG pro ( 190 € including Case) and would Like to Put in some phat Cats i have from an other Project.

    Can Someone Tell me which cable needs to put where? The pickups should work in the down Position. Thanks in advance!!
     

    Attached Files:

  2. plankton

    plankton Well-Known Member

    Joined:
    Dec 4, 2016
    Messages:
    1,009
    Likes Received:
    946
    Location:
    Adelaide, Australia
    Personally, I would replace those push/pull pots at the same time. I had them in my G400 Pro and they were rubbish. Plus you don't need them with the Phat Cats.
     
    dub-setter likes this.
  3. Karl R

    Karl R New Member

    Joined:
    Mar 26, 2020
    Messages:
    18
    Likes Received:
    24
    The red wire is the hot and the outer Black wire is the main Ground wire . Hope this helps!
     
  4. Beery Swine

    Beery Swine Active Member

    Joined:
    Jul 14, 2018
    Messages:
    137
    Likes Received:
    69
    Location:
    Philly, PA
    Humble request: Record A/B comparisons with the exact same setup, riffs, and/or solos in both clean and dirty, and heavy distortion if you want, to hear the differences and post to youtube.
    Maybe it's just me, but it seems like there aren't as many comparisons between pickups of differing types out there.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice